Hello,
i just purchased a WD10EARS 1TB recently to use as my second hdd and
i have a ST3500312CS 500gb as my boot drive,
the first thing i experience after i installed my WD, the booting process is exremely long, usually it only takes less than 2 mins to boot, but now its takes more than 5 mins to boot,
then i checked the bios, i see that the WD10EARS is detected but the capacity is reduced to a mere 0mb, and not detected at all in the disk management,
i've tried it in my friend pc, and it detected with full capacity, i tried copying, and formating, it works fine, but when i installed back in my pc it still detected as 0mb
i've tried atola's hdd capacity restore, but instead showing near 1tb capacity, it shows -2 bytes as full capacity
http://blog.atola.com/restoring-factory-hard-drive-capacity/
and i havent restored it yet,
my motherboard: GA-MA-770T-ES3, my friend also use gigabyte mb but i forgot the serial
i just purchased a WD10EARS 1TB recently to use as my second hdd and
i have a ST3500312CS 500gb as my boot drive,
the first thing i experience after i installed my WD, the booting process is exremely long, usually it only takes less than 2 mins to boot, but now its takes more than 5 mins to boot,
then i checked the bios, i see that the WD10EARS is detected but the capacity is reduced to a mere 0mb, and not detected at all in the disk management,
i've tried atola's hdd capacity restore, but instead showing near 1tb capacity, it shows -2 bytes as full capacity
http://blog.atola.com/restoring-factory-hard-drive-capacity/
my motherboard: GA-MA-770T-ES3, my friend also use gigabyte mb but i forgot the serial
Facebook
Twitter
Instagram