What is Better an AM3+ or FM2+ Build?

JoMs Dakis

Honorable
Dec 15, 2013
5
0
10,510
I mean if i were to choose or to build from scratch then it would like these:

Processor: FX-6300 3.5GHZ
Motherboard: Gigabyte GA-970A-D3
RAM: 8gb Kingston HYPERX 12800/1600
GPU: Sapphire HD 7770 1gb GDDR5
$431

or

Processor: A10 6800k 4.1 GHZ
Motherboard: Gigabyte GA-A88XM-HD3 M-ATX FM2+
RAM: 8gb Kingston HYPERX 12800/1600
(and for future upgrades like AMD Kaveri)
$298

btw im not a fan of Overclocking. I just want to play the Next Gen. games like BF4,GTA 5,Watch Dogs games that is similar, most likely to Medium and High Settings and im very tight on budget :D

 


AMD tend to stick with a socket for a while, but it is possible they will choose a new socket for their next generation.
This isn't important though because when you decide to upgrade this CPU in the future, you will just upgrade motherboard, CPU and RAM together.
What is your concern with this?
 

JoMs Dakis

Honorable
Dec 15, 2013
5
0
10,510
Nothing but its just im really tight on budget hehe :D some says for a starter i should go to FX6300 with 7750 Gddr5 while some says go with A10 6800k(and wait for the release of Kaveri APU)
 

The FX processor is fine, you won't need to upgrade this for a few years.
You can make the build cheaper by choosing a cheaper motherboard.
What you will find limiting is the graphics card.
If at some point you want higher detail settings and frame rates, this is what you will need to upgrade.

 


What is the point in spending extra money on a motherboard that allows you to overclock?
The CPU performance at stock rates won't limit frame rates below what the graphics card can do at any reasonable level of detail.
If you did have the extra money to spend, you could spend the same money buying a better CPU in the first place.
By the time you buy one of these expensive boards with an FX-6300, you could get a Core i5 with a cheap motherboard instead.
Even better, you could use the money for a better graphics card that will actually increase performance.

 


For a given CPU, over clocking can improve performance.
Rather than paying the additional cost of an expensive motherboard and cooling though, you can buy a better CPU running at stock rates.
You can buy a good quality motherboard without the over clocking features.

 

Anyone Youbet

Honorable
Jan 27, 2014
1
0
10,510


Personally I found that new A10's are out and in a FM2+ socket, read the reviews.
I think I am going for the Athlon I I x4, I want a matx with one pcix16
Going middle of the road, and going with the good reviews.
Not a over-clocker fan , so I want the computer to do the video part of the system , but not on the motherboard.
With that said I would go for the FM2+ socket, but I want the CUDA cores on my Video card, So I go with The Athlon rather than the A10. I have not found out If the A10 would work with the CUDA cores, also it seams the video cards are limited using the chip set. Also the system boards for the FM2 are slowing down at this point and will go up in price.
All components of my build will be $80 for each pics.

AM3+ -------- FM2+................$80.
AD750KWOHJBOX
ASUS A88XM-A FM2+
ZOTAC ZT-40401-10P GeForce GTX 460 768MB 192-bit GDDR5 PCI-E 2.0 VIDEO CARD
frame rate that combo, the last one is ebay seller, not sure about that one.

DDR3 2400 8 gig using two simms
My point is , it is hard to find a smaller motherboard that does not have on-board video.
and that also will be a good fast setup.