When i put RAM in other slot screen wotn respond

[Sqwebble]

Hi guys , i added my ram in other slot and my system booted , but screen did nothing and said no signal

Motherboard: H81m-p33
CPU: i3 4170
gpu : Gygabyte windforce GTX 1050
Ram : 1x8 gb 1600 mhz and other 4 gb 1600mhz

 

[keatingscool]

First question I have to ask. Is this a new RAM stick that you just purchased? If so which one is it the 8gb or the 4?. Next usually when screen is blank after you just installed new equipment will either mean that stick of RAM is bad or the slot that you put the Ram in is bad. Go ahead and swap sticks around to see if its the slot that is bad. Take the new one out and try both slots with the old. If that is the case then the new stick of RAM is bad. Also since I don't know much of the specs of your RAM, make sure you got DDR3 RAM that is supported by your motherbaord. Hope this works for you.

 

[Sqwebble]

First question I have to ask. Is this a new RAM stick that you just purchased? If so which one is it the 8gb or the 4?. Next usually when screen is blank after you just installed new equipment will either mean that stick of RAM is bad or the slot that you put the Ram in is bad. Go ahead and swap sticks around to see if its the slot that is bad. Take the new one out and try both slots with the old. If that is the case then the new stick of RAM is bad. Also since I don't know much of the specs of your RAM, make sure you got DDR3 RAM that is supported by your motherbaord. Hope this works for you.

Yes , my ram is ddr3 and both sticks are good ive tested it hundred times

 

[keatingscool]

Do you have an onboard speaker? Loosk like this

https://www.amazon.com/dp/B002W4M0DW?tag=tomshardware_forum_vgl-20

 

[keatingscool]

Install the new RAM again.
With the PC power unplugged, hold the power button for 30 seconds.
Plug power back in and try to boot.
Also, if you have the monitor connected to a graphics card and have onboard graphics as well, try plugging monitor into onboard graphics. The BIOS might reset after changing RAM and the display went back to onboard.

 

[Sqwebble]

Install the new RAM again.
With the PC power unplugged, hold the power button for 30 seconds.
Plug power back in and try to boot.
Also, if you have the monitor connected to a graphics card and have onboard graphics as well, try plugging monitor into onboard graphics. The BIOS might reset after changing RAM and the display went back to onboard.

No , it didn work , but yes I have onboard speaker but its not plugged in

 

[Sqwebble]

I downloaded manual instruction and I plugged it in JFP2 and nothing changed , im pretty disapointed 🙁