Question Where to connect case fans? Theyre not working

[screwrecaptchas]

I have a MSI b450 gaming pro carbon and a rotanium temper-tg302 RGB case which comes with 4 pre-installed fans. These fans are 5 pins. The case also comes with a controller which has 8 slots for 5 pins, a few slots for 2 pins, im not sure what goes there and a sata cable which also has a part that connects to a wire that connects to the motherboard. I initially had the 4 fans connected to the controller and then had the sata connected to a another sata cable which was connected to my HDD. The RGB worked ( it has a small remote with rgb buttons) but the fans were running at 100% and they wouldnt show up on my motherboard BIOS. It would says 0rpm for the system fans. Now i connected it through a SATA cable and to the motherboard, tried system_fan 1 2 3 and 4. Fans spin again at 100% but no information on bios. And now the RGB isnt working. Tried doing it just through motherboard but this time nothing spins and no RGB. Tried connecting it to the PSU sata cable and motherboard, no RGB but 100% spinning and no information on BIOS.
Can anyone please help me?

https://imgur.com/a/eIMDdfC

View: https://imgur.com/a/eIMDdfC
pics of the controller.

 

[scout_03]

you have any user manual for this case since could not be find on net you may have to contact seller case was made in china .

 

[screwrecaptchas]

you have any user manual for this case since could not be find on net you may have to contact seller case was made in china .

yeah no manual. Ive tried contacting them and theyre not too sure either.

 

[scout_03]

i seen on the case a rgb contol button and what other cable are in this hub appart the fans ones .

 

[screwrecaptchas]

i seen on the case a rgb contol button and what other cable are in this hub appart the fans ones .

It came with a remote control that controls the rgb. The hub has a red slot which connects to a sata. This red slot also has another part which connects to a wire which is connects to the motherboard fan header. It is a 3 pin.

 

[scout_03]

this means it receive power from sata port connector from psu and the 3 pins is use as signal cable for fans .