Where to connect fans? Motherboard or Fan hub?

[Vimalfxartist]

Hello,

My config is,

Sabertooth 990FX R.2 MotherBoard
FirePro V5900 Graphic Card 2 GB
4 x 4 Ram 16Gb DDR 3 Corsiar
1TB and 2 TB Hard drive
Phanteks Enthoo Pro white
Noctua NH D15 air cooler
FX 8370 processor

My doubt is,

there are 2 fans for NH D15 cooler and those are connected to the fan hub. But still they are very slow in running, I mean they are running in very low RPM. Even I can see how much its rotating through my eyes. Its very slow.

Should I need to connect it to my mother board? How to increase the fan speed for NH D15?

 

[ThatAfricanDude]

Connect it to the motherboard cpu header and such, because then you can control the fan speed and curves through your bios and also software such as msi afterburner i believe.

 

[Sakkura]

It just depends where you want the fans to be controlled, through the fan controller or through the motherboard BIOS (or software). For a CPU cooler it would usually be best to plug into the motherboard, since it's already set up to adjust fan speed according to CPU temperature.

 

[Vimalfxartist]

Connect it to the motherboard cpu header and such, because then you can control the fan speed and curves through your bios and also software such as msi afterburner i believe.

ok thank you

 

[ThatAfricanDude]

Pleasure, goodluck.