Where's best to put fans

[Dazzer1892]

Ive ordered a new pc case the aerocool strike x cube and id just like to know where people think i should put the fans,

The front can hold 1 x 200mm or 2 x 120/140

The top is the same as the front and the back is 2 x 120/140

Preinstalled on the case is 200mm at the front and a 120mm at rear

This is my 1st build so im new to all this but i thought i could possibly have 2 x 140 at the front for intake and 2 x 120 at the top and rear both exhaust, would this be ok i would be very grateful for any help
http://www.amazon.com/AeroCool-MicroATX-Controller-StrikeX-Cube-RED/dp/B00QGW7KRM

 

[Fatal_1]

id use the 200m fan in the front it will push a lot of air and its silent, just fill all your spots for fans up and youll be fine

 

[Dazzer1892]

If i have the 200mm at the front though will all the other 4 fans have to be exhaust fans because i read the top and rear fans should be for getting the heat out

 

[Eliasand]

The preinstalled fans are enough. The front will suck in fresh air, that will cool the components, then get sucked out in the rear and repeat.

Although that case might be a bit small. It doesn't support a full-size PSU, nor a big graphics card. Something like a CM Elite 120 would be a better option.

 

[Fatal_1]

just have the top and the rear fans as the exhaust

 

[Dazzer1892]

The graphics card can be upto 320mm and the power supply is a standard atx, so i should be ok with just the preinstalled fans then that would be good if the case because the fan controller only has two 3pin connectors