Will my PSU fit

[iwentturbo]

Will this PSU fit in my case? https://www.newegg.com/Product/Product.aspx?Item=N82E16817139196&cm_re=500w-_-17-139-196-_-Product
Case: Height: 36.40 cm (14.33 in)
Width: 37.80 cm (14.88 in)
Depth: 16.31 cm (6.42 in)

 

[Xibyth]

What case do you have is more important. The raw dimensions of your case doesn't specify it's power supply clearance.

 

[iwentturbo]

I have this case https://support.hp.com/gb-en/document/c05278338

 

[Xibyth]

Unfortunately no, but your system does in fact use the standard power supply cables. The issue is your system is UATX, so there is the possibility with a new case with an ATX or MATX form factor. Then you can use any standard power supply. I'll put an inexpensive option below.

https://www.newegg.com/Product/Product.aspx?Item=N82E16811353049&cm_re=matx_case-_-11-353-049-_-Product

 

[madmatt30]

From every picture I've seen it does actually look like a standard atx psu is there (albeit a short one)

Open the case , measure the PSU itself .

Post the measurements here.

If it will take an atx PSU then the vs is not the unit is buy honestly , its a new model so nor entirely sure of its quality but if its anything like the older vs series it won't be very good

 

[iwentturbo]

6 in wide and 4 in tall

 

[madmatt30]

Not very specific mate but sounds atx size/spec to me

Would have preferred all 3 measurements in mm/cm

What's measurement internally from front to back of PSU ??

As long as you have 140mm clear to play with there are loads of Psu's you could use.

 

[iwentturbo]

Could you dumb that down for me? Not very good with PC terms

 

[madmatt30]

^ take the side of the case off so you can see the psu.

Measure its length from where It touches the back of the PC case to the opposite end where all the cables come out of it.

In cm call that length

Measure its height from top to bottom

In cm call that height

Measure its width from one side of the case to the other in cm

In cm call that width

On the back of the case the psu should be fixed with 4 screws , measure the distance between the centre of the top 2 screw's in cm.

Measure the distance between the top left screw & the bottom left screw in cm.

Post all 5 of those measurements back here.

 

[iwentturbo]

Length: 14 cm
Height:about 9 cm
Width: 15 cm
distance of top 2 screws: 14 cm
top left to bottom left screws: 7 cm

 

[madmatt30]

Definitely atx.
So yes it'll fit fine.

But you should go for this one , $5 more , far better quality

https://www.newegg.com/Product/Product.aspx?Item=N82E16817151094&FM=1

 

[iwentturbo]

Alright, thanks for all your help