Windows 7 problems after installing updates

FortMac1

Distinguished
Sep 17, 2011
5
0
18,510
0
Installed updates and after the reboot a warning message is up saying pc video resolution is out of range, change setting to recommended resolution 1280X1024@60Hz, and the rest of the screen is black.
 

FortMac1

Distinguished
Sep 17, 2011
5
0
18,510
0


I do not see that option, it shows the following:
Please select boot device
1st FLOPPY DRIVE
SATA:pM-ST3500418AS
CDROM:SM-HL-DT-ST DVDRAM GH22NS
IDE:Maxtor 6Y160P0
 

FortMac1

Distinguished
Sep 17, 2011
5
0
18,510
0

I do not see that option, it shows the following:
Please select boot device
1st FLOPPY DRIVE
SATA:pM-ST3500418AS
CDROM:SM-HL-DT-ST DVDRAM GH22NS
IDE:Maxtor 6Y160P0
 
you may have a motherboard that uses f8 as the boot menu--bit stupid really not to use f12 etc as all windows use the f8 key to get to usefull options

but just select whichever hard drive your windows is on probably the sata on and once it comes out of the boot menu press f8 again as its going to load the operating system then
 

FortMac1

Distinguished
Sep 17, 2011
5
0
18,510
0



I had f8 pressed during the start up, and it is asking to select boot device ( one of the four listed previously). I tried the first two and nothing changed, the same warning is dancing around the black screen, the PC video resolution is out of range.....
 
it should be the 2nd or 4th one you listed earlier they are both hard drives--or try f5 that may also give you the safe mode option--just continously tap the key if you only press it once you may do it too soon or too late
 

FortMac1

Distinguished
Sep 17, 2011
5
0
18,510
0



my apologies for the late reply, booting up in safe mode successful, however, was not able to restore to previous date, so I had to take it in to the experts. Don't have it back yet, hopefully I will have some results soon.
 

Similar threads