XMP Profile enabled but doesn't work

[willz.setiawan]

I have ASRock B450 Pro4 and TEAM T-FORCE Vulcan 2x4 (8GB) DDR4-3000 RAM
but the problem is my RAM speed is running at 2400mhz, so i tried to enable XMP Profile 1 to make it 3000Mhz but doesn't work, after enabling that I check my RAM speed again in task manager > performance but it's still the same.

BIOS version is the lastest 1.80
CPU: Ryzen 5 2600x

 

[unknownofprob]

Hi Willz,

It is most likely just showing the default clock of the module (being 2400, XMP alters a few timings and variables), and not the speed shown of that to the XMP profile. Double check your BIOS to see if it was saved, and triple check by performing a benchmark. I would never use task manager as an accurate source of information over a BIOS.

 

[Calvin7]

Someone else with same problem in Newegg reviews.
"Running at 2400 on b450 aorus pro wifi"

I would try manually setting memory parameters. If 3000MHz is too much, try next lower speed.
Model TLRED48G3000HC16CDC01
• DDR4 3000 (PC4 24000)
• Timing 16-18-18-38
• CAS Latency 16
• Voltage 1.35V

 

[willz.setiawan]

Hi Willz,

It is most likely just showing the default clock of the module (being 2400, XMP alters a few timings and variables), and not the speed shown of that to the XMP profile. Double check your BIOS to see if it was saved, and triple check by performing a benchmark. I would never use task manager as an accurate source of information over a BIOS.

Then where should I check my RAM speed after enabling XMP Profile 2.0, because task manager is easy to look for RAM Speed

 

[willz.setiawan]

Someone else with same problem in Newegg reviews.
"Running at 2400 on b450 aorus pro wifi"

I would try manually setting memory parameters. If 3000MHz is too much, try next lower speed.
Model TLRED48G3000HC16CDC01
• DDR4 3000 (PC4 24000)
• Timing 16-18-18-38
• CAS Latency 16
• Voltage 1.35V

I've done this manually too, and still the same nothing changed, thanks for the answer