Z97 VGA Red Light HELP

[flexmyfoil]

Good morning all, please help.. I have recently purchased a Z97 Gryphon MB, after the install/build it was time to power her up..

Unfortunately it gets as far as the VGA check but the red light stays on and no display.

I have a usb mouse, usb keyboard and HDMI monitor connected.

Some photos attached, hope they help.

SPEC

Thanks

Darren

 

[Calvin7]

I don't believe it is realistic to believe that you can successfully power the motherboard with a 150 watt Streacom ST-NANO150.

(From page 1-36 of downloadable manual)
Do not forget to connect the 4-pin/8-pin EATX 12v power supply.

Use a power supply that complies with ATX 12v Specification 2 (or later version) and has a minimum power of 350 watts.

see graphic chart - 16. Power Consumption And Efficiency
Pentium G3258 CPU Review
http://www.tomshardware.com/reviews/pentium-g3258-overclocking-performance,3849-16.html

Pentium G3258 - TDP 53 watts
The Thermal Design Power (TDP) is the average maximum power a processor can dissipate while running commercially available software. TDP is primarily used as a guideline for manufacturers of thermal solutions (heatsinks/fans, etc) which tells them how much heat their solution should dissipate.

 

[flexmyfoil]

After trying a different power source with 500w it still will not boot! We also tried the nano150 on another PC which boot fine. Something up with the MB?