Zotac 610 no signal bad mobo?

[rayy1212]

Hello Panel of experts i have been working on building a HTPC (home theater pc) and it consists of the following

Foxconn R20-I400 D2500 NM10 R barebone kit

I replaced the 150W PSU with a Seasonic 350W PSU

it has 4 GB So-dimm

A 1 TB Western Digital HDD

an LG Blue-ray drive

and my problem is a Zotac geforce gt 610 (PCI interface)

I'm hoping to get it blue ray ready, and the 610 works fine in another system so it isn't the card I've tried a lot but I'm at my wits end on this one, perhaps there's something in the BIOS I'm missing?

 

[house70]

Does the motherboard have integrated video, as well? In that case you need to enable the PCI video in BIOS.

 

[rayy1212]

It does have integrated video, but the only controls that i have found in the bios related to it are controls for dedicating system RAM as V-ram. I'll take another look tomorrow when i get a chance and ill post back any other recommendations are welcome as-well.

 

[house70]

Should be something along the lines of "enable PCI video"... maybe even a jumper on the mobo. For the mobo to NOT support PCI video would be a bummer; check the manual if you have it, or online.