We tested the Nvidia App performance problems — games can run up to 15 percent slower with the app
Entire Intel Core 200 laptop lineup leaks out — Intel prepping to launch 22 new mobile CPUs next month at CES 2025

Toggle sidebar Toggle sidebar

SkyNetRising

Titan

Joined: Jan 4, 2016

Latest activity Postings Featured content About Trophies

- SkyNetRising replied to the thread Question Guys can anyone tell what ram and how much capacity is supported on this laptop. It comes with this ram..
  
  Those are DDR3L modules. Work at lower voltage than normal DDR3 (1.35V vs 1.5V). Check BIOS options in your laptop. See, if you can...
  
  Today at 3:57 AM
- SkyNetRising replied to the thread Question Guys can anyone tell what ram and how much capacity is supported on this laptop. It comes with this ram..
  
  Max memory supported is 8GB. So 2x 4GB DDR3 SODIMM 1600mhz. Ram will work at 1066mhz though. But it will probably be easier getting...
  
  Today at 3:07 AM
- SkyNetRising replied to the thread Question Restarts during backup into UEFI.
  
  Don't use sleep. Use shutdown instead. And disable hibernation. powercfg -h off
  
  Yesterday at 1:52 PM
- SkyNetRising replied to the thread Question Where to connect the ARGB Input cable?.
  
  You connect that chain to a molex connector from PSU.
  
  Yesterday at 10:38 AM
- SkyNetRising replied to the thread Question Where to connect the ARGB Input cable?.
  
  Can you find, how your pc case fans are connected? Or if they are connected at all?
  
  Yesterday at 10:35 AM
- SkyNetRising replied to the thread Question Where to connect the ARGB Input cable?.
  
  Normally fans should be spinning. How are fan cables connected? Each fan should have aRGB connector and fan connector. ARGB is for...
  
  Yesterday at 10:29 AM
- SkyNetRising replied to the thread Question Where to connect the ARGB Input cable?.
  
  Yes. Since your motherboard doesn't have appropriate aRGB connector, you leave it unconnected.
  
  Yesterday at 8:56 AM
- SkyNetRising replied to the thread Question How to change old Windows hard disk to new hard disk?.
  
  Either clone or clean install. Should work. When all write cycles are exhausted, drive will switch into read only mode. Should be at...
  
  Yesterday at 8:53 AM
- SkyNetRising replied to the thread Question Where to connect the ARGB Input cable?.
  
  Connect this way.
  
  Yesterday at 8:30 AM
- SkyNetRising replied to the thread Question PC shuts off after 5 seconds, but stays on if RAM sticks are removed ?.
  
  I'd suspect some device causing this. Disconnect all USB devices, all storage devices (sata, nvme, optical drives), all rgb and all...
  
  Yesterday at 6:08 AM
- SkyNetRising replied to the thread Question Which component is likely the cause of the crash on boot please help?.
  
  Could be: ram, graphics card, unstable power delivery (PSU).
  
  Friday at 1:05 PM
- SkyNetRising replied to the thread Question Which component is likely the cause of the crash on boot please help?.
  
  And still couldn't get into windows? Try setting memory frequency to 3200mhz. Can you describe those "crashes", you're getting? Is it...
  
  Friday at 12:57 PM
- SkyNetRising replied to the thread Question Problem with m2 ssd.
  
  So .. with 980 installed you can not get into BIOS and with 980 removed you get into BIOS just fine. Correct? That seems like some...
  
  Friday at 12:51 PM
- SkyNetRising replied to the thread Question Problem with m2 ssd.
  
  Can you get into BIOS after BIOS reset? What BIOS version are you using? Try updating BIOS to latest version.
  
  Friday at 12:47 PM
- SkyNetRising replied to the thread Question Which component is likely the cause of the crash on boot please help?.
  
  Check ram placement. With 2 module configuration modules should be placed in slots A2, B2 (grey color slots). If you have four ram...
  
  Friday at 12:34 PM
Show older items
Loading…
Loading…
Loading…
Loading…