As I know it is a standard ATX case. The model is KENDOMEN. Below is its link:
https://www.deepcool.com/products/Cases/fulltowercases/2021/15203.shtml
The specification table says "Power Supply Type ATX PS2"
Hi
I am going to replace my dead COOLER MASTER v650s PSU with MSI MPG A650GF.
OLD PSU: 120 mm fan, 140*150*86 mm
NEW PSU: 140 mm fan, 160*150*86 mm
The fan grille of old PSU fits exactly with the 115*115 mm ventilation panel at the bottom of my DEEP COOL case. I don't have the MSI yet, but...
Disconnect all case fans, usb connections, etc and try to power on PC with as minimum as possible parts. Just use one module of RAM. This way you may figure out something.
Your PSU might be OK. However, to be sure about the proper functioning of the PSU you can use the paper clip technique. I just want to eliminate the PSU issue so you can go to test other parts.
Hi,
I need your advice on which one to choose, build quality and long lifetime are important:
MSI MPG A650GF
CORSAIR RM650 (RM650X is not available here)
MSI is cheaper and has more warranty time than CORSAIR in my country.
Thanks in advance for any recommendations.
Hi, I have a question about the PSU hold-up timings.
I've googled and found out the definition of some PSU timings. These are things that I know (or I think I know):
hold-up time (>17 ms)
AC loss to PWR_OK hold-up time (ATX T5>16 ms)
PWR_OK inactive to DC loss delay (ATX T6> 1 ms)...
The VGA seems to be the most probable cause of the problem. Since your CPU does not have an integrated graphics, there would be no way other than swapping VGA. Not a solution, but, disconnect VGA from MB and PSU then power on PC and look what happens to the LEDs on the MB.
Hi everyone,
Not sure, but, there is a contradiction between the review and specs of this PSU in MSI's official site. The fan type reviewed by Aris about 15 months ago is DBB, however, MSI says it is FDB.
Maybe this is not an important issue by itself, but, throws doubt on the validity of...