Recent content by bquick

On the pc that says "undefined network" Open up the Command Prompt, and type "ipconfig /release" -without quotations and then type "ipconfig /renew" -without quotations See if that fixes your issue, post back with the results and if that doesnt fix your issue run this command "ipconfig /all"...

Use the "ipconfig /all" command to check your ip address on your computer. That will be the ip address you need to forward to.

You don't need any other hardware for your computer, but you will need a wireless modem or wireless router for connectivity.

In your router their is configurations to only allow internet activity during certain times of the day. I would log in to your router's web interface and check those settings.

On both devices post a screenshot of the "ipconfig /all" command then we can further assist you.

When you configured your linksys range extender what did you set the default gateway too?

The first step would be to restart all of your networking equipment. (Routers, Switches, and modem) If that doesn't resolve your issue then get a laptop and plug it directly into the modem to bypass all your other equipment, and see if you can access the internet. If that doesn't work contact...

I've removed this one several times actually. Combofix will be able to remove this, but even if you get into safe mode you will still get the fake fbi virus to cover your whole screen. I highly suggest using hirens rescue cd and then run combofix. You said you can't boot from cd or usb make sure...

If you can boot into the computer regularly. Go to run and type "msconfig". Go to the boot tab and check safe mode. When you're finished in safe mode you will have to repeat the process and uncheck the safe mode option and save.

When you right click on the shared folder. Go to properties > sharing tab > advanced sharing tab. From there make sure the "Limit the number of simultaneous users to:" at least 50 since you have 40 users.

Install it on a flash drive from a computer that has internet.

I suspect the page is a calibration page. If so you need to allow it to print and then place it face down on the scanner bed and press the scan button, the printer will then complete the calibration and you should not have to do this again until the next time you replace a cartridge. Note that...

Since you want it wired, a crossover cable would allow you to transfer data between two PC's, allowing you to stream the movies from your file server.

You will need to create a dhcp reservation for your printer. Without knowing your exact model of your netgear wireless router, you should google the steps for your wireless router it's a pretty simple fix. Post on how it goes and if you need any more help.

Computers and laptop give a beep code after going through POST to offer a method of troubleshooting. One beeps means the test passed and everything is functioning. If it beeps multiple times, you need to look that up depending on your motherboard. Is it just one beep, or multiple?