Recent content by camrd33

I'm looking to connect a monitor via usb to hdmi in the monitor. However, I'm unsure of how to set this up and whether to use USB-C or just USB 3.0. Any help would be appreciated!

All fans spin including coy fan so I would guess cpu?

cooler*

I only have one stick of ram and I do not have another mobo available. Do you think it’s the thermal paste or cOiler?

When powering on I get a short abrupt beep after running for a while and it turns off and tries to boot again

I don’t remember whether it was core or socket sorry. And I can’t check because I can’t get a post on the screen. I remember the the case temperature was 35 degrees so I think it is well ventilated.

I just used the thermal paste which comes applied. This is a pc I just built. Specs are 500w psu, asrock mini itx AM4 AB350 mobo, ryzen 2400G with stock cooler

CPU temperatures extremely high while idle. Temps went up to 125 and system turned off. It now won’t post. Any help is appreciated

MERGED QUESTION Question from camrd33 : "PC Won’t boot. Motherboard connector won’t go in" At first I had the 24 pin connectors in the wrong ports (mobo end in psu). I used quite a bit of force pushing it into the psu port before realising it was incorrect. Now the correct end won’t quite go in...

Hi, Yes that is my connector. It however does seem to have a small gap between the cable and the psu when I plug it in, and when plugging it in I didn’t get the click sound that all the other cables did.

PC Won’t boot. Discovered that the 24 pin connectors were plugged in wrong places (mobo end in psu). After fixing this the pc still won’t boot. I did apply a lot of pressure on the psu when plugging in the wrong hole. Could this have done damage? To where? Any help is appreciated

Hi, my reasonably new pc has started acting up. The system automatically powers on when power is given to it. With the led strip flashing and the lights on my mousepad flashing. The cpu fan is running slowly but there is no post on the screen

I was looking to get 8gb ram (2x4) for now until I have the money to upgrade to 16. But I am unsure now as ive seen that ryzen will drop the speed of the sticks to 2133mhz. My question is could I overclock these sticks back up to 2400mhz safely? I am doing this on a ryzen 1200 OC to around 3.8ghz