Recent content by clintwilks

The 110 should most definitely fit this board. I'm using same board/cooler at the moment. line the slots up that are diaganol from each other if you're not already doing that. do it one at a time

Best answer selected by CLINTWILKs.

is 1.28v with LLC on next to highest setting for 4.5ghz a pretty crappy chip if you're talking 3570K?

Schultze I have the Asrock Extreme4 with 3570k and have spent literally hours upon hours doing nothing but trying different voltage settings with each different llc setting with each different ram setting/c state settting/ etc and if you're okay with 4.5ghz then i can send you some settings to...

well you paid for 1866 and it wont hurt anything to run it at 1866 so might as well. you should be able to just go in and manually set the mem frequency to 1866 and manually set your timings instead of just enabling the xmp profile. However, they are right on the above posts. As far as...

ALthough it is obviously best to run stability tests for extended periods of time, me in my naive ways thought if I doubled up and ran a prime95 blend with a ITB 10 pass stress test on HIGH stress setting together at the same time, I could pretty close to rest assured that my PC would be stable...

CCode: 101 BCP1: 0000000000000031 BCP2: 0000000000000000 BCP3: FFFFF880009EE180 BCP4: 0000000000000001 OS Version: 6_1_7601 Service Pack: 1_0 Product: 256_1 Files that help describe the problem: C:\Windows\Minidump\022213-6052-01.dmp...

stickem what case do you have? usually if you have it blowing as intake its much louder than if you have it as exhaust, so if you are using stock clocks or low overclock that shouldn't be a problem to reverse it. i'm running a CM storm enforcer case with 1x 200mm front (exhaust) the h100 top...

Best answer selected by clintwilks.

eh....i went ahead and just got the h100 and some prolimatech pk-3..and yes...the 612 sucks. worse than the 212 idc waht anyone says. but thanks for the response. you get best answer !! lucky you!!!

the mobo light should be doing that. no problem there. first i'd plug it directly into the wall while checking things out unless the power at your residence is unusually faulty or you feel it would be dangerous to your components to do so for however long it takes to check things out. sounds...

good to hear congrats on your first successful build...rarely goes according to plan :)

hjahaha i live in atlanta georgia and those translations well... anyway, with as many people that do it being successful first try, if i screw it up then i deserve to have a f'd up processor. at that point, i will attempt to make it look as close to it did when i bought it as i can and take it...

no i was reading up on it more first, still have pony semen in there. gonna wait on the pk-3 i think..dotn really have anything else that would be decent right now. only TIms i have right now are dow-corning DC-5121 (Enermax), cooler master stock paste that comes with hyper212 evo and as5.

i have no choice but to mount the rad on the outside correct? or is there some way to mod this to where it would fit inside? i have enough space, per se, but not for it to fit in the pre-made screw holes. the most WC ive done is my H100..which doesnt much count so, i want to try and figure...