Recent content by Codrru

if it is not enough have both rad fans going in and just use the rear fan and psu to exhaust.

oh ok i see, if thats about the space you are working with, switch the psu to pull down from gpu it exhausts out the back, front rad fan into case, rear rad fan and rear case fan out of case. run it for a good while and see if that changes things.

your laptop isnt being shutdown its going into sleep state. for true shutdown right click the shutdown you should be able to see a different option you basically want a full admin shutdown. you can also google that for exactly how to do it with your particular laptop. wifes started doing that too.

well if the psu is for sure good, then yes in this case it sounds like a bad board. not much you can do but rma it.

what is your fan setup

partly what you think, high heat followed by cooling, but most likely it is also combined with the case having either too much pressure or too negative pressure. maybe adjust some fans to balance so it is only partially positive pressure inside and check the temps if those check out then come...

hmm, well only thing i can think of is coil whine or bad bearing so ill bow out.

most likely it is coil whine. easier to google that term for the full description, but assuming it is not and the power is regular i would say bad bearing. most likely if it is not refurbished then the store that you bought it at got a roughly handled shipment. honestly though i wouldnt be too...

well if it was in fact the motherboard the psu(especially the evga gold) should trip the pc into a forced shut down. not make sounds, this place you are buying them from are they selling them new or pre used/ refurbished?

no worries

ok any word on the revision? because the rev 1.3 can handle 4 gb ram and the 1.4 can handle 8. assuming it is the one that can handle 8 the cas latency and timings seem ok, but in this particular swap your old stick with severely restrict the new one. can the old stick run a higher mhz and stay...

i concur with MWP0004 case paint coats are measured in microns the flakes or chips will be about the size of dust particles, and heavier than them. keep positive pressure in your case(more air in than out) and they will fall to the bottow where you can easily clean it all out but most likely...

i still say noctua but it may still be out of price range for the moment. so if its literally just a little while this should work...

http://www.googleadservices.com/pagead/aclk?sa=L&ai=DChcSEwi34IW38IzQAhVGHYEKHcNgAycYABAN&ei=jFQbWOXOK4PWmAGao52QDA&ohost=www.google.com&cid=CAESIuD2q5LMywMIs0-FL84ZhZY-dg-QiukgixaR6otGIDl8tYo&sig=AOD64_02s5i6CkfEhJiONNpxWlzpvJIbeQ&ctype=5&q=&sqi=2&ved=0ahUKEwjlxIC38IzQAhUDKyYKHZpRB8IQ8w4IlAE&adu...

https://en.wikipedia.org/wiki/Voltage_regulator_module easier for you to read than me to explain, simple terms it regulates current on the board, but it can be the hottest running part or parts on any rig and if hot enough can overheat a cpu. thats why i mentioned making sure the case has a...