Recent content by Drew125

I found this in the dump file. With the dump file pointing to the intel processor driver it is going to be 1 of 2 things. 1. your CPU is overclocked incorrectly and unstable, in which case I recommend reset all overclock values to default. 2. Your PSU is failing to deliver enough power and...

I got the SSD installed and cloned. and wow at the boot times. My server went from 1200 seconds to boot down to 256 seconds. its so much faster.

That works for me

Its wd 3d nand 1TB. It is very short on ram. However it is maxed out. It can only hold 16GB of ram. At this point in time i dont have the funds to make what i need so im making what I have work. But i dont want the endurance score to drop because of page file usage. I will post a picture of how...

I have a quick question about a new SSD drive i have ordered. I plan to use it in my makshift server, an old 2015 business PC. It uses a lot of pagefile, the servers take huge amounts of ram. It has 16 GB of ram. After 3 server boot its using 25 GB of RAM and allocated 31 GB. So its basicly...

As an update it seems that drive failed. Every day the sync module has disconnected at the same time. After a reboot a message follows backup failed. After 4 days of trying stuff i put a different usb in it. This time a sandisk. Backup successfully last night no disconnect. It seems the walmart...

It seems to be. I just had to lose the clips on he drive. I am going to run data recovery on it. I’ve made a note that when it looses power pull it and check it immediately.

It is. for clarity the power blinked while the usb was in the camera system. Not my pc . Thats where I think the corruption happened

I have a flash drive in my security camera system. Its a walmart 128 GB formatted exfat. I pulled it out and was going to pull some video it froze the whole pc. I tried on another pc same issue. I brought out my surface and tried a chkdsk it froze at 0% would not move. Tried to copy the data...

Crash # 1: FAILURE_BUCKET_ID: 0x3B_c0000006_nt!HvpGetCellPaged Crash # 2: IMAGE_NAME: memory_corruption ERROR_CODE: (NTSTATUS) 0xc000000e - A device which does not exist was specified. DISK_HARDWARE_ERROR: There was error with disk hardware KERNEL_DATA_INPAGE_ERROR (7a) The requested page...

I will check the dumps and get back with you. It will be late before I can. Most likely after 10 PM Eastern time.

That is the key right there. I run it on a Surface pro 3. I have no issues with it. Just a few minor bugs here and there. I would let it grow for about a year then consider upgrading your main system to it. As a play system its ok. i just would not make it your main.

Your issue is going to be 1 of 3 things Cpu over heating, id recommend running hwmonitor to make sure the cpu temps are not higher than 70 to 79C. You throttle around 80 to 88C and turn off at 90 to 100C The power supply can't keep up and it shuts down due to low power. The only way to test...

Basically the consumer router firewall allows very basic port forwarding/triggering and prevents outside connections from just barging in. that's it. This router has a option to disable port scan and dos protection and keep the basic firewall up. So far fingers crossed logs look clear, no Dos...

That's my exact thought. If its just scans and it seems to be turn off DOS protection. The protection is eating the resources worse than an actual attack. I know why this network is being hit so hard. When the modem was replaced they plugged their pc directly into the modem for about 6 hours...