Recent content by Dsmith18

Thanks, I found that thread while searching as well but haven't done what some of the users have suggested yet. I'll give it a shot.

Hey guys, Recently I've noticed that my GPU's fans have been really loud, and upon taking a look at them while they operate, I've seen a few things: 1. The fans seem to go from 0% to 100% with no in between. I've been using the ASUS software to watch my card's performance, and I can't seem to...

I just looked in the motherboard manual and it says that it supports DDR4 2133MHz modules but the Ripjaws I have are 2400 MHz, could this be the problem?

Hi, I finished my build last night and had the same problem I'm having now: the PC turns on for about 15 seconds with nothing showing up on the monitor then restarts. my debug LED on the motherboard displayed the error code for "Memory Initialization Error." I fixed this by realizing that I...

Wow, I just think I found the problem myself. The RAM I was testing must've not been in all the way because when I took them out and put them back in, they work. Before the BIOS wasn't coming up on screen and the debug LED was giving me the code of "Memory Installation Error" which now makes...

I finished building my new PC but when I turn it on, it doesn't connect to my monitor and automatically shuts down after about 18 seconds. It then restarts again doing the same thing over and over. I have already deconstructed the PC to only be using the CPU, Motherboard, and PSU and the problem...

Hi, I just finished putting together my first pc build, and when I turn it on everything lights up and the fans start running, but nothing ever shows up on my monitor and after 10 or so seconds, everything powers off. Then after a few more seconds, it powers back on and the cycle continues. What...

Hi, currently in my build, there are three front fans which are serving as intake. I am planning on putting one 120mm fan on the rear and two 140mm fans on the top. Which should be exhaust and which should be intake?

Hi, my graphics card (Asus Strix gtx 1070 OC) has a single 8 pin connector for the power supply, the problem is, my PSU (EVGA Supernova 650 G2) only came with two 6 + 2 and 6 pin connectors for the VGA. Would it be ok if I used the 6 + 2 from the cable and just left the additional 6 pin hanging?

I'm currently working on my first PC build and everything was going fine until I ran into this problem with my fan hub: I don't know how to install it. I have the Thermaltake Commander FX - 10 Port fan hub because my itx motherboard only supports one case fan. The problem is the hub is powered...

Ok so you think everything along with that will work together fine?