Recent content by FireworksON

The problems above have been solved, i think i had connected the wrong pins. But i got a new problem,it struck again, showing " |-->setup versioninfo tag... Starting kernel ... Uncompressing Linux... done, booting the kernel." Entire: Boot SPI NAND k3 U-Boot 2013.04 (May 14 2019...

Here is the same steps from a forum.

The last one seems do not connect anything, why it's RxD? Sorry,i don't have a multimeter at hand, so I can't detect them.

It seems that it had been connected,but when i tapped "Space" Key, it just showed "INTERRUPT", what the problem? And when I tap the "ENTER" Key, the "⇒ "turned into " y>" . Please help!

Sorry, if it had been connected, it should have printed much more,but in fact it didn't,and i couldn't type in anything, there must be sth wrong.

How to figure out the holes below, Which one is Tx,and RX,and GND. There are no marks on the board, it's a Chinese modem board. I don't know how to figure them out, so I looked through many posts from many forums,and at last I connected them.However I got the logs below,It just stopped there, it...