Recent content by gpapamic

Thank you Zerk2012. It seems that the hard drive is set as the boot device so it doesn't look at the CD. How to reset CMOS if I can't get into the bios?

Hi all, I switched to ahci mode and whenever my pc starts it prints "ahci bios installed !". Problem is I cannot load the bios at all! (and therefore I can't boot from CD since the hard disk is selected on top of the boot devices) what to do ? Thanks

I bought new sata cable (what the heck, 1.50 euro) and connected the ssd on that. No success?? same reset port error. When I change the port the same message from the other port. I started thinking about speed: the mobo has 6 sata ports, each one supporting 3Gb/sec of data. The new cables and...

The "port reset error" only comes up for a fraction of a second. I changed the power cable and it's still the same. Switching drives like that also didn't work: I get the same error and then the usual "insert system disk to continue". I don't know, perhaps my mobo is too slow for that kind of...

I have tried different sata ports and when the pc boots up before the bios I get that "reset port error" on the port that the ssd is connected (eg "port 01: reset port error !"). I am now going to try different power cables.

Thank you for your reply. Problem is, the bios does no detect and list my ssd so I can't select it. Is there something I can do to make it visible?

Hi everyone. I upgraded from 7 to 10 and used the Minitool Partition wizard to clone my hdd to a new ssd. Now I have both disks and the one that boots is the hdd. I used as ssd benchmark to check if the disks are configured properly and everything ok. So far so good. When system boots I get the...