Recent content by Inulo

system memory ..? I tough ram and system memory is the same thing?:)..what is the max temp for RAM modules?

Just tried with no gpu load still hot so it is not the gpu ..maybe it was running like that since I built it but neve noticed ( 1 years) .The question stil remains is 70-80s degrees bad for ram and what is the reason to each that dgrees.Ram is ddr3

Could it be the backplate of the 980ti keeping the heat in emitting towards tthe ram as titan has no backplate and is cooler on the top side and I assume that is why ram i the other pc is cooler too

Hi guys I have xeon 1240v3 and 980ti 6gb with 32 gb kingston 4x8gb hyper x . Now I have the cpu and gpu runing 100% load cpu 66 degrees gpu 75-77% 24/7 mining.Just noticed that my ram when I touch feels hot like the backplate of the 980ti I would say 70-80 degrees. I tried runing software to...

Hi Rot it is not the wires but where theyare plugged mostly ti pushing to the pins and plug for the led and power

Hi Guys, It seams that I can't fit the card in that motherboard as it is pushing on the power button and led connector is that possible or I should just push it harder :) it is a question of a 0,5/1 santimiters that is hard to judge. Otherwise I can't find a place where it says that that...

Hi ZRACE, Thanks. Well, I'll be honest, the jump from 2133 to 2400 is small. You'd have noticed it if you had 2666 and up though (e.g. 2400 to 3200 gives ~15% boost in intensive workloads)"" I higlly doubt that is possible as far as 3d rendering in Vray is conserned : from cpu 3.1 to 3.6 i...

Yes BIos is upd to date the lates version. NOw I just made a test Irun a vray rendering test that had 1min:25 sek to render the scene ram was at 2133mhz ( cpu at 3.6) I had the ram at 2400mhz and same result no boost in CPU performance. I watched some clips about enabling XPM but strange in my...

ZRACE thanks So it is not the RAM ? as I said I don't need and I don't want the ram to run higher than 2133mhz..Ok I will try higher voltage I have set auto voltage so I assume over 3.6 it is needed manual setup of the voltage

Hi Rexper, Thanks for the answer ..""Also, your ram should be working at or around 3000MHz"' ..but 2x16gb is 2400mhz ram?..it can't get higher that could it? ..( 2x8gb is 3000mhz but i thought one channel is limitted by the other ) as I said I don't care about ram performance all I am trying...

Is that the problem that I need to overlock the ram too in order to get higher clocks in the cpu ?

Hi Guys, I don't know much about overclocking but got a ryzen 1700 station for rendering. MOtherboard : ab350m-gaming 3 .. Ram: 2x8gb 3000mhz Corsair savage 2x16gb Adata 2400mhz premier I don't care about ram speed ..so I overclocked cpu to 3,6 and is runing stable 60degres on 100%...

no :( tried changing the thermopaste .. same story ..tried fullspeed mode of fans same thing..maybe downclocking it t0 3.3ghz instead of 3.4 ? anyone has any idea what should be done?

my motherboard is Asrock b85m pro 3 maybe a bios update issue?

i installed fanspeed and it shows cpu fan speed:1700rpm while speecy detects it at 1350rmp?