Recent content by jumbojo

Sign into ps3..go to network settings

Atheros AR8131 PCI-E Gigabit Ethernet Controller is what I got..I would suppose I can use a higher setting,yes? All Iam seeing is either 10,100 or auto 10/100 mbps ?

Should/could I try the high speeds? How would I find out if my network adapter supports "gigabit ethernet" ?

Well, a friend suggested I try using one of the LAN connections instead of the WAN,so I did and seemed to get internet access yet limited. So I accessed the dlink router setup page and locked mps to 10.. I then shut everything down and reconnected using the manufacturer instructions for setup...

Its up and running! Thank you for all the help!

Ok,I will try again and get the ip address Yes the lights light up and flicker..yet when I just my internet status it shows 2+ million packets sent and 0 recieved?

I do not have new router setup at this point because I cannot get online to discuss or view the suggestions on here..at this time my ip is 192.168.1.???

Thanks for the quick reply Hawkeye22! Ya I dont know whats going on!!?? "Power up the modem first. Wait until it goes online (may take a couple minutes), then power up the router. Wait for it to finish booting, then boot the computer." When I power up the modem,will the internet connection...

Os is windows xp Received the replacement/new one finally...Still cant seem to get an internet connection!!!?? :fou: Followed manufacturers instructions etc...not sure what to do? If I plug old "Linksys" router back in everything works fine...shut down comp,transfer wires over to new...

Thanks again..sent router back for replacement,will check back when I get new one and try hooking up

Yes and yes..but ya it says exactly that "unable to display page or timed out"

Im wondering if there is something I can try on my end before I send it back? Or by me not being to access the router configurations,does this mean there is no luck?

Ya I couldnt access my router when I tried to setup my dlink dgl-4100 so thats why I was told to return it. Right now Im using my old router a linksys befsr41 which is working fine..yet I was looking to speed things up with the dgl-4100 hopefully

Thanks for the reply! How do I findout? Do the start,run,"cmd' ? And what exactly am I to set to DHCP and how? Thanks for any help!

I bought the D'link DGL-4100 router and the Motorola surfboard extreme modem..had issues with router,could not access router settings or internet when connected to D'link,tried using old router and everything worked fine After trying different cord,hard reset and spending about an hour total on...