Recent content by Kalmado

Thank you for trying so much to help. I've left a post on MSI's site as well. Hopefully it can get worked out.

When checking bios it states the version is from 4/23/12. That is the only version on Gigabyte's page. http://www.gigabyte.com/products/product-page.aspx?pid=4602#bios Is there somewhere else for a more updated bios?

So far still no display. Just so we're on the same page there is no display from the second the pc boots. Cannot see bios. Pc is running.

Hardware: cpu: fx 6300 mb: Gigabyte GA-78LMT-USB3 v 5 ram: pny 8gb 1600 psu: xfx 550w 80+bronze gpu: msi r9 280 I can't get any display after installing the gpu. Can load without just fine. In bios, set to PEG. In device manager, disabled on board. Nothing has worked. Card does power up, fans...

Fixed! After updating Bios AND ME (Intel Management Engine) everyone is good!

Hardware: cpu: Intel Pentium G3258 MB: MSI Z87-G41 Ram: Gskill Ripjaw 4gb 1333 gpu: MSI R7-260 1GB psu: Corsair CX430 hdd: WD Blue 1TB Whenever I try to restart pc (after update, change, etc) or after exiting bios I do not have display. PC is running, but monitor goes into power save mode. If...

Some of the threads I had looked at and one thing that stands out is to either downgrade BIOS to 1.7(1.9 is currently installed). Since the pc will not recognize any flash drive I'm not sure how to do this. And with MSI's site down I cannot download their forum flash tool. I may just have to...

With MSI's forums down until the 21st I do not have a direct resource. I was planning on building a secondary gaming/computing pc and I do not need to have usb 3.0 nor necessarily need to have the flash drive access, but obviously it would be nice to have! And this way I wouldn't essentially be...

I was so mad when I bent those pins yesterday! The DIMM clip was just icing on the cake. I'd rather sell it on ebay and get $30 or so than spend more money. This board was going to be to sell in a build as well. I'd keep it for myself, but like I said I cannot get the usb ports to recognize a...

Under usb config I only have the following below. All are set to enabled. usb controller xhci hand off ehci hand off legacy usb support After switching everything to a new case and having the same problems I think I have no choice but to get rid of this board. Unfortunately for me I bent the...

Tried switching the usb header but no luck. I'm going to try it in a different case before shipping it off. Hopefully it works!