Recent content by kevopj

Hello, Please assist! Putting together a build with an Asrock Nova Z790. On page 37 of the manual it shows the VRM fan connector. I am at a complete loss as to what cable I need to hook this up to a Corsair HX1000i power supply. These are both apart of a Phanteks NV7 for what its worth. Please...

Thank you for the response and help! The case has a male and female 3 PIN ARGB connector. I believe the female is the controller to sync with the motherboard and the male is for expanding DRGB products as it states on the instructions. Based on this, should I connect the controller to the Aura...

Hello, I am currently in the process of building a PC and have questions about where the Phanteks G500A D-RGB cables should be connected to the Asus Z790 Hero Motherboard. The case has 3 RGB fans and I also added an additional RGB one for exhaust. I also have a Phanteks LED Strip 1 Meter and...

Hello, I am currently in the process of building a PC and have questions about where the Phanteks G500A D-RGB cables connecting to the Asus Z790 Hero Motherboard. The case has 3 RGB fans and I also added an additional RGB one for exhaust. I also have a Phanteks LED Strip 1 Meter and Neon...

Hello, I have just recently been experiencing Windows 10 boot up issues which I believe has ruined a hard drive which is irrelevant at this point. I am trying to find the root cause of this, I think I may have figured it out but I'm seeking advice please. I have a Phanteks Enthoo Evolve ATX...

I think I've decided to forget LED fans since they are kinda hidden anyway with this case and will just go LED strips.

I am thinking about buying the Phanteks Evolv ATX Tempered Glass case but am looking to maximize the cooling while keeping the noise down. This comes pre-installed with 2 x 140mm fans in the front and 1 x 140mm fan in the rear. It can handle 3 x 120mm in the front and top. I am thinking about...

I've heard the W_PUMP header is for actual water cooling systems and not hybrid coolers like the H50, is this true?

Hello, I am helping a friend build a computer soon and I am just trying to make sure I connect his Corsair H50 to his ASUS Z170-A properly. The manual (last file) can be found within the link. Headers are on page 14 and 37. The motherboard doesn't appear to have a PWR_FAN header. However, it...

Hello, I currently own this card.... EVGA 770 I am thinking about purchasing this card..... EVGA 970 I am curious as to how much of a performance gain if any I will see. I am looking to reduce heat output, noise, but also improve performance on my rig. Any help is greatly appreciated, thank you!

Asrock works awesome.

I believe I have found the issue being with the Network Adapter's power management. If I turn all these features off within the Device Manager the problem is gone. Wish I didn't have to do this though... And..... its back, nevermind. How do you change video card bit rates?

Replacement hardware just came in, not even going to bother installing it. Going to try an Asrock board. Installing my Geforce 480 produced the same exact results on the Z97-A..... while both cards perform fine on my previous Intel board. This was done in Windows 7 versus 8 and with bare minimum...

I am noticing when browsing new power supplies they are advertised as being 4th generation Intel ready (Haswell) which is what I just installed. My power supply is an older Corsair HX850W(Silver) which was bought in the midst of the first generation of the i7 series. Is this a possible reason...

And if your not overclocking and the problem persists?