Recent content by Majorai

  1. M

    Possible CPU Dying.

    Hello, I'm looking for some assistance with a boot-up issue I think is down to a CPU failing. When I attempt to boot my PC, it will load, very slowly, to the Windows splash screen (the swirly balls), and then immediately reboot with no BSOD (this also happens trying to get into safe mode) It...
  2. M

    Memtest86 - No errors, but locks up?

    No worries, I appreciate the help :).
  3. M

    Memtest86 - No errors, but locks up?

    Apologies, forgot I had posted this. After deciding to buy more RAM, no errors whatsoever. I was pretty confident that it was set up correctly in BIOS (and with no overclock). Marking your reply as a solution in the hope that if someone has similar issues, they check BIOS before buying new RAM...
  4. M

    Memtest86 - No errors, but locks up?

    So I have been having a lot of blue screens with my main PC, at least once a day. Specs: i7 4970k @ Stock 16GB Corsair Vengeance DDR3 1600MHz MSI Z97-G45 Gaming Mobo MSI GTX980 x2 SLI The Blue screens I'm getting are usually one of the following (I get at least one every time I boot up): Page...
  5. M

    Looking for case recommendations - Rad support etc

    I'm looking at getting a new case for my current set up: i7 4790k MSI Z97 G45 Gaming Mobo MSI GTX980 2-way SLI The main features that I'm looking for are both front 240mm radiator support (pref. push-pull), and at least 1 side fan to keep my GPU temps down. Although a mid tower would be...
  6. M

    Possible shorting between Motherboard and case

    Thanks for the reply clutchc, turned out that the centre stand off supplied with the case was slightly different, I just needed to remove it and swap it to one of the spare standoffs.
  7. M

    Possible shorting between Motherboard and case

    I decided to change my case from a Nanoxia Deep Silence 1, to a Corsair 500r. However, when I attempted to start the computer the leds and fans start for a fraction of a second, then any subsequent attempts produce nothing. I have made sure I am connecting the front panel correctly. If I put all...