Recent content by |Onka|

Solved!! Probably quite unique and unlucky problem but will post here anyways! It was the mobo! I had my friend come over again and built my rig on hes motheboard and all worked fine. So I quess I am just that unlucky that my original motherboard failed, bought a brand new one to test the...

So now..by accident... I have noticed that the new mobo will start up when the cpu 8pin is NOT connected..ofcourse then the cpu wont get any power so it doesnt exactly solve the problem...but I thought it was interesting. I tried plugging in all 12 pins but didnt help, i tried to swap them a...

Probably doesnt mean anything but there are 12 pins for CPU. Manual says to plug 8pin or 8pin and 4pin. I have allways just used 8pin connector and have had no issues.

Okay interesting. All the connectors are properly connected, cpu 8pin connector even shows red light when it is not connected. Yes I am aware of that and will be using the cooler. Tried with the other board..doesnt give me anything, just a "tick" but nothing boots up.

Alright. Thanks, did not know that one about amds. I tried with the bare minimum and get the same results... no post and error 00. Right now I have the cpu without the huge cooler on top..and have noticed that the cpu does NOT heat up at all when turning on. When I tried with my friends pc...

Would it not even POST without gpu? I can see the POST process on my motherboard with the led signals. But I will try. No bent pins, there was a tiny bit thermal (non conductive) earlier but i cleaned it out. I am new to AMD and the socket is weird but as far as i can see there is nothing...

Actually, just noticed. I put the motherboard under my table, where the is plastic cover to protect the floor from the wheels of my chair, so the motherboard was on top of plastic.

Now I tried with one stick, 24pin, no 8pin, no hard drives, no gpu. With the original MB. Error code 00 and no POST.

I put my motherboard on floor, laminate floor. Cooler was off since it's so large that i cant get to MB screws when it is installed, but CPU was still in MB. Before reinstalling I took CPU off to clean it with isopropanyl. The minimun I have tried has been without any hard drives or m.2, one...

Hi. First of all let me list my pc specs before I forget to:D - AMD Ryzen 7 3700X -G.skill ddr4 4x8gb -asus rog strix x570 motherboard -Asus strix 1080 oc gpu -EVGA 750w PSU -m.2 -noctua cpu cooler (cant remember model) Right. So I swap my cases..wanted less noise, smaller and more compact...

Yeah so my debug leds flashed CPU and RAM repeatedly as did my last motherboard too. But I should have probably updated this since i found out the problem. I had my cpu blocks backpanel too tight wich was doing somesort of interruption for my other channel i suppose. So for anyone with the same...

Hi! Ive posted a few times now about my pc not booting with dual channel, only on slots 3 and 4. I RMAd my motherboard thinking its motherboard issue and they contacted me back saying theres one pin bent and transistor burnt above dimm slots. I was relieved, knowing that the issue was on...

Alright so i found out that in mb settings there were some sort of setting about windows 7 and 10 and it was enabled for windows 7. I enabled windows 10 and the killdisk thing went gone but still didnt boot but started to "repair disc" now i am resetting my pc if it will work.

I had same problem with my old board. Soi thought what are the chances to get 2 motherboards with broken channels. Could my ram be the thing that destroys my motherboard?

I just googled killdisk is some sort of formatting tool. Does that message mean that all my data is gone now ?