Recent content by Tomas Talaat

No it's not pluged into wall always each time after shutdown i remove the PSU cable from wall

sometime when i boot up the PC the LED light remain and when i restart the PC the LED light Go Away But that happen from time to time because always when i Power up the PC it run smoothly with no Light but sometime when i power on the PC the LED light remain and just after i restart it it run...

No that happened before BIOS update and still occur after BIOS UPDATE ( I made bios update in order to fix that problem )

MSI MAG A650 BN

My Motherboard is Asus Tuf Gaming B850m-plus wifi , It has EZ debug led . Sometimes the GPU LED ( White ) Still on ( constant white ) after booting and when i Restart the PC the LED light Gone away . I updated the BIOS , I test The GPU and it works greatly , I did Stress test for GPU and it was...

Yes they have their own software and I can control them via it I mean when I use one software such as single RGB or open rgb to control all components the SW doesn’t recognize the devices connected via usb it only recognizes mb , ram , Gpu

Can I control RGB peripheral devices such as ( Keyboard , Mouse - that connected via USB ) be controlled via Software like Single RGB or Open RGB ?? ## note : devices are Red Dragon Brand

Temperature during running thw windows is 80 C and on Benchmark its 86 C and on stress test its 95.5 C ? Is that Normal

Room temperature range from 30 to 35 I am using AMD stock cooler My case is Xigmatek cubi II ( 7 fans , 6 of them allow air in and one fan air out )

My New CPU is ( Ryzen 5 8400f ) it's Temperature in idle mode is 55 C So is it normal or NOT ?

I am Building New PC So i need to Test PSU and Case fans only before installing The remaining components PSU ( MSI A650 BN ) and Case ( Xigamtek Cubi with 7 fans on Fan hub work through molex cabel )

Can i test the PSU by connecting it ( through molex cabel ) to Fan hub only without connecting the Motherboard or NOT ?

it's Thermal paste pre applied to AMD stock cooler I just Installed the Stock cooler ( i didn't applied the thermal paste it's preapplied to stock cooler ) but then within few seconds i removed it to re adjust it , took a picture of CPU ( attached ) Then i re installed the Stock cooler again

I removed the stock cooler to re adjust it well . there is no problem in cables . the Problem that if i removed the heatsink and installed it again before turning on the pc Does i need to replace the Thermal paste due to air bubbles or not I haven't monitered the Temp till now but i will do it...

So I'm building my first PC and I have a heatsink with pre-applied thermal paste which I attactched to the CPU but took off briefly to reajdust its position. Will I need to remove the thermal paste and put a new layer on now? note that i haven't Turned the PC till now . I haven't turned on the...