Hi,
I have a 4790k currently running at 4.2ghz with my vcore at 1.071v offset voltage.
my build is in a corsair 760t full tower
I have two intake fans at the front, one intake at the bottom, one exhaust at the rear and my h110i gt rad with the two fans exhaust.
I have a h110i gt cooler and the pump water temps are at 33.7c using blend prime 95 and 34.1c.
using intel burn test
I am using the supplied Thermal paste that was preapplied to the cooler.
my ambient temp are at 29c
my rad fans are running at 1800rpm
my pump is running at 2800rpm
I am doing a prime 95 v26.6 stress test blend test and am getting max temps of 59c
when using intel burn test and running it on maximum 67c
my idle temps are lowest 29c
With reviews on various sites they are getting much cooler temperatures than me and im wondering if the pump has been fitted properly?. I have the backplate installed as it should with the notches in the backplate in the correct area. from the look of my water pump temps and the stress tests themselves does this seem correct/normal?
should i go through the hassle of remounting my cooler?
I have a 4790k currently running at 4.2ghz with my vcore at 1.071v offset voltage.
my build is in a corsair 760t full tower
I have two intake fans at the front, one intake at the bottom, one exhaust at the rear and my h110i gt rad with the two fans exhaust.
I have a h110i gt cooler and the pump water temps are at 33.7c using blend prime 95 and 34.1c.
using intel burn test
I am using the supplied Thermal paste that was preapplied to the cooler.
my ambient temp are at 29c
my rad fans are running at 1800rpm
my pump is running at 2800rpm
I am doing a prime 95 v26.6 stress test blend test and am getting max temps of 59c
when using intel burn test and running it on maximum 67c
my idle temps are lowest 29c
With reviews on various sites they are getting much cooler temperatures than me and im wondering if the pump has been fitted properly?. I have the backplate installed as it should with the notches in the backplate in the correct area. from the look of my water pump temps and the stress tests themselves does this seem correct/normal?
should i go through the hassle of remounting my cooler?