Question after installing new ram it wont boot to windows 10

[Benjamin17A]

motherboard: ASUS B85M-G
OS: win10 pro 64 bit ver: 1909

currently have a 1x8gb ddr3 ram 1800mhz installed in 4th slot DIMM

I bought a 1x8gb ddr3 ram 1600mhz, then I insert it in 2nd slot DIMM and turn on my pc and go to BIOS, the system detect the 1x8gb ram on 2nd DIMM, however when booting to windows 10 I get a blue screen that say "Your PC ran into a problem and need restart . We restart for you." then it will automatically reboot again and again(looping).

When I remove the new ram it works fine but the bios can detect the new ram when install on 2nd slot DIMM, so I try removing old 1x8gb ddr3 ram from 4th slot DIMM then insert the new ram on 4th slot the issue start to occur it will boot the blue screen of death then restart by itself again, does this mean the new ram that I bought is defective or do I need to adjust some configuration on my BIOS settings?

 

[rgd1101]

exact model of the new and old ram?

 

[Benjamin17A]

exact model of the new and old ram?

Old and new are kingston hyperx not sure if this is the model your looking for.

 

[rgd1101]

Old and new are kingston hyperx not sure if this is the model your looking for.

A good start but not the exact model. it should have the speed and timing

 

[Benjamin17A]

A good start but not the exact model. it should have the speed and timing

Okay it shows on CPU-Z on SPD tab(Old ram): PC3-14200(889 Mhz)

On Memory tab(Old Ram):

DRAM frequency - 798.1mhz
FSBRAM - 1:6
CAS# Latency(CL) - 9.0 clocks
RAS# to CAS# Delay(tRCD) - 10 clocks
RAS# Precharge(tRP) - 9 clocks
Cycle Time(tRAS) - 26 clocks
Row Refresh Cycle Time(tRFC) - 208 clocks
Command Rate(CR) - 1T

Unfortunately, for the new ram all I can say it's a kingston hyperx fury 1x8gb ddr3 ram with 1600mhz, since it wont boot the windows 10 but the package includes PC3-12800