Applied Too Much Pressure on motherboard????

[Veynox]

Hey guys today i opened my computer to see if i could make a better cable management (first time im opening a computer inside and messing around) and i want to reroute the 24 pin connector, i tried to pull it out while holding the side button but no luck (pc is prebuild so it could be glued) when i gave up i noticed that the connector was not fully pushed in and i applied some pressure and which flexed the motherboard about 1 to 2 centimeters. now to my main point im afraid i could have damaged the motherboard and its not visible yet (btw didnt hear no creeks or snapping sounds) should i be worried and what should i look for to see if theres any damage done. once again im a noobie and im sorry if this was confusing but i tried to describe what happened as best as i could (motherboard is pegatron btw)


Thank you for your answers guys, i would also like to ask do you guys know how i could push the pin connector all the way in cause it seems to be 1 milimiter out but idk if thats really a problem or not

 

[getochkn]

First, it wouldn't be glued in. They don't glue them.

Second, only way to know is to turn it on, see if it boots.

 

[ahnilated]

What can happen is that the plastic sticks after numerous heating/cooling cycles. Motherboards are very resilient and can take a lot of abuse from pressure.