Hi all, I've just bought the above board 2nd hand, everything works great, apart from my case fans, now, I'm unsure as to whether 3 pin fans are true pwm units or not, but the setup with my old intel board was my 2 rear 3 pin case fans (exhaust) off the rear chassis header using a 2 way splitter, and my front and top 3 pin fans (inlet) off the front chassis header using an identical splitter.
however, this Asus board has one header marked chassis fan near the rear of the board, and another identical header labeled power fan slightly further over and lower down near the pcie slot, the rear ones that are connected to the chassis one behave normally, but the pair connected to the power fan header just go flat out regardless of what I tell qfan or anything else in the bios to do, speedfan also doesn't do anything to help me.
To me the logical thing would be to get another splitter and just run all 4 from the chassis header, is 4 80mm fans ok off a single header or would it be too much load?
Many thanks in advance
however, this Asus board has one header marked chassis fan near the rear of the board, and another identical header labeled power fan slightly further over and lower down near the pcie slot, the rear ones that are connected to the chassis one behave normally, but the pair connected to the power fan header just go flat out regardless of what I tell qfan or anything else in the bios to do, speedfan also doesn't do anything to help me.
To me the logical thing would be to get another splitter and just run all 4 from the chassis header, is 4 80mm fans ok off a single header or would it be too much load?
Many thanks in advance
Last edited: