Asus P8h67-M PRO BIOS FLASH NOT WORKING

[Shog40]

Hi I have a p8h67-M PRO (rev 1.05) Motherboard i need to flash BIOS from v0902 to v3604 or greater to use new cpu Intel i7 3770 But in all my attempts i get "ez flash image integrity check failed" or "Not UEFI FILE" i have have created a FAT32 Usb followed steps read forum after forum with no help at all...

Hoping if someone could help me out PLease!

 

[StaticHS]

Yes.

 

[Shog40]

Yeah still no luck still a On and off (repeat)

 

[alexoiu]

Test the board outside the case, only CPU and CPU fan installed, both 24 and 8 pin cables connected. See if still on and off. Is there a CPU fan backplate installed?

 

[Shog40]

Not that i can see ill give it a go

 

[Shog40]

Well I did what you advised and it made things worse I unplugged everything left CPU 8 pin and 24 pin in. Turned it on started up didn't turn off. So plugged everything back in then turned on again with mobo back in the case and but now it runs for about 1 minute then turns off with no post so I take CPU out plug in the old one same thing happens runs for about a min no post then switches off but everything works even the DVD/cd rom..

 

[alexoiu]

Leave the board outside the case for testing. Install the old CPU. Check firstly the CPU socket for bent pins.
If OK, install the CPU fan, single RAM stick, graphics card, DVD drive, keyboard and mouse.
Start the board outside the case. When getting the new BIOS chip?

 

[Shog40]

Between Wednesday and Saturday they recon

 

[Shog40]

So do plug a screening answer?

 

[alexoiu]

Plug a screening answer? What do you mean?

 

[Shog40]

Sorry stupid auto correct plug in a screen as well ?

 

[alexoiu]

Yes, connect the monitor to the graphics card.

 

[Shog40]

Ok. I have plugged in everything you said. Everything is running hasn't switched off yet. But still no post.

 

[alexoiu]

What graphics card using? Does it require PCie power cables? Are they connected?

 

[Shog40]

Yes and yes

 

[Shog40]

It's nvdia GeForce gtx 660

 

[alexoiu]

In this case you would need an internal case speaker attached to the motherboard
http://www.newegg.com/Product/Product.aspx?Item=N82E16812201032
for further troubleshooting.

 

[Shog40]

Where would I plug that in? Can't see a connection for it.

 

[Shog40]

Oh wait found it

 

[Shog40]

Ok does it have to be that specific brand or can I get one located in my country?

 

[Shog40]

Ok so what code are we hopping it beeps when I get one?

 

[alexoiu]

Any brand would do. Start the board with only CPU and CPU fan installed, 24 and 8 pin power cables connected, speaker attached and you should get 1 long 2 short beeps.
If no beeps, then it's either a board or a CPU issue.