ASUS Z270F where to connect FAN Cantroller ?

[exefusion]

Hi,
i bought a new Case(Define R6 Black). this one has a built-in fan controller (Nexus smart HUB) and i added a new custom watercooling System
my question is now where do I plug in all fans and the controller?

I have 3 fans for the radiator water cooling System which I would plug with a y-cable to CPU_FAN. I can control them in Fan Expert.
The pump on AIO_PUMP
now I have 3,4 pin fans which I would connect to the hub. where do I connect it?

and is it normal that I can't control the pump via the connection AIO-PUMP? in Fan expert 4 it shows a pump but the RPM FIX mode is deactivated? is there a solution for that?

and sorry for my bad English ^^

 

[alexoiu]

"now I have 3,4 pin fans which I would connect to the hub. where do I connect it?"
A bit vague. Could you detail?

"is it normal that I can't control the pump via the connection AIO-PUMP?"
How many pins on the connector, 3, or 4?
Have you checked in BIOS if control mode on DC, or PWM?

 

[exefusion]

"now I have 3,4 pin fans which I would connect to the hub. where do I connect it?"
A bit vague. Could you detail?

"is it normal that I can't control the pump via the connection AIO-PUMP?"
How many pins on the connector, 3, or 4?
Have you checked in BIOS if control mode on DC, or PWM?

in bios it was on Dc, I changed it to PWM.
after the reboot I looked in fan expert and still can't change it there.
if I plug the pump into CPU_FAN I can change it with PWM


so here is a link where u can the pics form the BIOS
https://drive.google.com/drive/folders/1Nc96M4zMWB9bK3tka3CYrkHEgjk26beH?usp=sharing

 

[alexoiu]

Even if not listed, the BIOS should be able to control the pump. However, I would let it run at high speed.

 

[devbiker]

On the Asus motherboards, the AIO_PUMP header has fan control disabled by default. To enable it, you need to go into the BIOS and enabled Q-Fan Control for the header.
That said, I'd leave it as-is as well.