ATX standoffs misaligned, help?! (Picture inside)

[Nitas]

So I'm building a new system, and my Asus Z270H board doesn't fit with the ATX standoffs in my Fractal Design Define S case. What the heck is going on?? I'm kind of freaking out because this is one expensive build!

Take a look: http://imgur.com/a/ha8Xv

 

[SkyNetRising]

The board is a bit smaller than standard atx.
You have to use one additional plastic standoff to support your board.

 

[Nitas]

No plastic standoffs came with the mobo or case :/ The mobo "fits" but the hole on the far middle right won't be used, and there is no hole in the case for it either.. I don't get it.

 

[SkyNetRising]

No plastic standoffs came with the mobo or case

Then get some.
http://www.ebay.com/itm/Lot-of-10-M...894763?hash=item41ac4236ab:g:KKQAAOxyYYlRtX56

 

[Nitas]

Well where am I supposed to use them? There no other holes in the case.. can it be that it's only those 6 holes who're supposed to be used?

 

[SkyNetRising]

That plastic standoff doesn't require a hole (in the case).
It just supports the motherboard, so it doesn't bend and doesn't touch anything it shouldn't.

You could as well use something like this to support the board
(if getting a standoff is too complicated):