Bleep codes on start-up

[kutline]

Hello. I might need some guidance with an issue I'm having.
I have been recently getting some beeping and alarm noises from my Pc. Whenever I start it up I get:
-Alarm-like noise going for about 10 seconds.
-1 long beep and 4 short beeps (failure of some component, aparently)
-And a no signal on my monitor.
Specs:
CPU: I7 3770 (non-k)
GPU: GALAX GTX 980 4GB
RAM: Corsair 8 GB DDR3 1333MHz
MoBo: Asus Z77-A
PSU: Xilence 750w
I should mention that I moved the Pc and I might've been a little rough. So I heard a fan slowing down, everything seemed fine, there was inpit on the gpu, cpu etc. I then restarted the PC and ended up here...

 

[Phillip Corcoran]

Open the case and check that all add-on cards and cable connectors are pushed fully home.

 

[kutline]

Open the case and check that all add-on cards and cable connectors are pushed fully home.

I did do that.
I also took off the fan to see if the chip fried, which wasn't the case. I blew off the dust with a hair dryer set to cold air. I placed the RAM into a different slot (1...stick...8GB)
I'm gonna try this again later after I get home.
In the meantime, any other suggestions would be great