Question Can’t install Windows 10 on new PC

[Jonbryant00]

Hello,

Last week I tried installing Windows 10 on my new PC via Windows Creation tool on a brand new USB drive. But every time I boot my PC up it’ll load my USB and TRY installing Windows but it freezes every time. I’ve tried every USB port, I’ve tried deleting and downloading the Windows Creation Tool back on to my USB multiple times but every bootup it freezes

My system specs are:
MB- ROG Strix Z390-E
Graphics Card- GeForce RTX 2080
Processor- Intel i7 9700k
Ram- Corsair Vengeance LPX 16GB 3000MHz
HDD- Seagate Barracuda 2TB
SSD- WD Blue 3D NAND 500GB

 

[rgd1101]

try with just 1 stick of ram? only the ssd connected? without the gpu and using only the igpu?

 

[Jonbryant00]

try with just 1 stick of ram? only the ssd connected? without the gpu and using only the igpu?

I’ve tried with one stick of ram and no luck, same without the gpu. I’ll have to try with only the ssd connected

 

[rgd1101]

check cpu temp in bios?

 

[Jonbryant00]

check cpu temp in bios?

Haven’t checked the temps but when I went to disconnect my hdd I discovered that the power cable wasn’t plugged in. It must have disconnected when I was doing the cable management. I plugged that back in and tried again and it seemed like it got closer to starting up the installation but it froze. So I tried again but with 1 ram stick and it got even closer like the rotating circle thing under the windows logo did its thing and went away but now it’s just the logo..