[SOLVED] can i use 1030 on dell inspiron 3250

[Anjisth]

hi, there i'm having a full pc issue regarding set up of things like my gpu 1050ti to fit in dell 3250.Config - i3 6th gen , 180 w psu , 1tb hdd 7200 rpm , 1050ti

 

[Anjisth]

my pc interiors where 1-optical drive, 2-fan,3- hdd, 4- motherboard, 5- idk

 

[Anjisth]

hi, i want to know that can i use 1030 on dell inspiron 3250,Config- 4gb ddr3l ram, 7200rpm , 180 w psu, i3 gth gen . I want to know wheter it can be supported or not

 

[Barty1884]

180W is a little bit thin, even adding a 30W GPU, but should be ok.
I'm not aware of any BIOS limitation that would stop the card running.

 

[Anjisth]

is it possible ?? without extender as im sending u this pic

please suggest where to put it

 

[Barty1884]

is it possible ?? without extender as im sending u this pic

please suggest where to put it

It should be, based on pictures I can find online....
This is your system, right?

 

[Gerald6049]

Which version the 1050ti you get ? You should find the Low Profile version for this models.
https://www.msi.com/Graphics-card/GeForce-GTX-1050-Ti-4GT-LP/Specification

And your PSU is too weak to handle the GPU. At least 300W or more.

 

[Anjisth]

ye

It should be, based on pictures I can find online....
This is your system, right?

 

[Anjisth]

yep

 

[Anjisth]

i was thinking of getting 1050ti normal after reading forms i think 1030 is better

 

[Gerald6049]

i was thinking of getting 1050ti normal after reading forms i think 1030 is better

1030 have lower power usage and perform slower than 1050ti.
It will be good for your systems. But if you can, upgrade the PSU later.

 

[Anjisth]

is there any model of 1030 with 4gb ddr5 as the one im finding are all 2gb

 

[Gerald6049]

is there any model of 1030 with 4gb ddr5 as the one im finding are all 2gb

No,the 1030 only have 2GB version.

 

[Anjisth]

I stumbled upon one more graphics card
Zotac Gaming Geforce GTX 1650 OC 4GB GDDR6 Graphics Card
is it feasible as i cannot change the case of this device due to holes and screws