Can't Access Router via Browser

[Zed95]

So I tried almost everything to access to my router and I can't
huawei hg531s v1

Help

Thank you

 

[gbb0330]

So I tried almost everything to access to my router and I can't
huawei hg531s v1

Help

Thank you

turn it off and back on

confirm the IP address of the router

run ipconfig and look for default gateway in the results.

try different ports, for example if your default gateway is 192.168.0.5 try 192.168.0.5:8080 or 192.168.0.5:8443

 

[VK7]

Contact ur ISP. And tell them to refresh ur mac address. And i think u also have take ur router to them, they will gonna do the router settings.

 

[USAFRet]

So I tried almost everything to access to my router and I can't
huawei hg531s v1

Help

Thank you

Are you trying to access the router wired, or WiFi? Most routers have WiFi admin turned OFF by default. What error message do you see?

 

[Zed95]

So I tried almost everything to access to my router and I can't
huawei hg531s v1

Help

Thank you

turn it off and back on

confirm the IP address of the router

run ipconfig and look for default gateway in the results.

try different ports, for example if your default gateway is 192.168.0.5 try 192.168.0.5:8080 or 192.168.0.5:8443

I tried, nothing seems to work.
It just come as Webpage is not available

 

[Zed95]

So I tried almost everything to access to my router and I can't
huawei hg531s v1

Help

Thank you

Are you trying to access the router wired, or WiFi? Most routers have WiFi admin turned OFF by default. What error message do you see?

Actually both :| wired and wifi ed
This webpage is not available

 

[Zed95]

Contact ur ISP. And tell them to refresh ur mac address. And i think u also have take ur router to them, they will gonna do the router settings.

I called them and they said they will send a tech tomorrow.
^This was 3 days ago

 

[AposMOveit]

Reset your router to factory defaults by holding reset button for 6 secs and then wait 5 mins and try again. Then check on Control Panel> Network and Sharing Center> Change Adapter Setting>Right click your network adapter (wifi or ethernet)>Properties>double click IPv4>make sure its set to auto.
Hope you didnt try to flash any firmware to the router!
Good luck!

 

[Zed95]

Reset your router to factory defaults by holding reset button for 6 secs and then wait 5 mins and try again. Then check on Control Panel> Network and Sharing Center> Change Adapter Setting>Right click your network adapter (wifi or ethernet)>Properties>double click IPv4>make sure its set to auto.
Hope you didnt try to flash any firmware to the router!
Good luck!

You are a f****** Genius MAN.
THANKS 😀