Can't Clear CMOS on MSI 970 Gaming Motherboard.

[Nightfate]

Hi, i ran into an issue.
1- Updated the Bios to ver. 22.3 MSI 970 Gaming Motherboard from M-Flash in Bios Set Up.
2- Then It rebooted and stock in the 99 number on the botton right of the screen.... Nothing Happends.
3- I reset, same, try to entering SetUp with the Flash connected, stock on "entering set up" with "99 number"
4- Removed the battery for like 30 min. Same.
What else i can do?
5- If i connect the USB flash drive with this version it boots to 99 number. If i don't , dosen't boot at all and i get "2 Beeps" every 2 seconds or so.I tried to connect the USB with a different Bios Version, nothing...
It seens that removing the battery dosen't do anything to the Bios, plz i need help. Everything was working fine...

 

[utroz]

There is usually a clear CMOS jumper that you need to jump with a jumper or any conductive item (screwdriver ect). Also was the power unplugged when you removed the battery? page 1-28 in your manual should show where the cmos reset pins are..

 

[Nightfate]

Yes i unplugged the power cord, i just put the Jumper, it should be with the power cord or without the power Cord?

 

[Guest]

Hi, i ran into an issue.
1- Updated the Bios to ver. 22.3 MSI 970 Gaming Motherboard from M-Flash in Bios Set Up.
2- Then It rebooted and stock in the 99 number on the botton right of the screen.... Nothing Happends.
3- I reset, same, try to entering SetUp with the Flash connected, stock on "entering set up" with "99 number"
4- Removed the battery for like 30 min. Same.
What else i can do?
5- If i connect the USB flash drive with this version it boots to 99 number. If i don't , dosen't boot at all and i get "2 Beeps" every 2 seconds or so.I tried to connect the USB with a different Bios Version, nothing...
It seens that removing the battery dosen't do anything to the Bios, plz i need help. Everything was working fine...

MSI state there is no going back to an earlier version, sounds like your bios file was corrupt that you was flashing with ?

 

[Nightfate]

i tried clearing the CMOS with the Jumper, if i turn the PC on with the jumper in dosen't make any sounds, with the jumper out has the 2 beeps sound.

 

[Nightfate]

MSI state there is no going back to an earlier version, sounds like your bios file was corrupt that you was flashing with ?

But i has to be a solution for this...

 

[utroz]

I did some research and one guy was missing the jusb_pw2 jumper on the pins (power to wake from usb) and it was causing the code 99. So might be worth looking into that..

 

[Nightfate]

I dont know what is that equivalent on my board.

 

[utroz]

Never mind your board doesn't have that.. Also when you reset the bios with the jumper you unplug the power from the wall then short the two pins with a jumper or anything conductive for a couple seconds, if this is jumped and you try and turn on the computer the computer will not work. So nothing at all shows up on the screen? It must be a bad BIOS flash and you will have to RMA it.. So at this point I don't think there is anything we can do to help..