CELERON 333 MHZ Help!!!

[Guest]

hi!
I just got from a friend a holco motherboard from shuttle (661VS155)wih a via appolo pro plus chipset, a slot 1 celeron processor at 333MHZ(66*5) and one 128mb sdram dimm from toshiba(PC100-322-722.with this mobo i can adjust the settings either from bios , either from the board with jumpers.from the bios i only could run it at 415mhz(5*83).from the board when i adjust the fsb at 100mhz or more it doesnt boot at all.also on the manual says that there a jumper(45),which if you take it off you could run 66mhz based processors at 100mhz or more.but when i do that the system still doesnt boot.could you help me here, because i have stuck!!!

 

[Crashman]

First of all make sure your memory is 8ns or lower (lower ns=faster memory). Then if it still won't go try raising the voltage .1v

Suicide is painless...........

 

[Guest]

there is no setting on the motherboard about the voltage!!!

 

[Guest]

Did you try 4x100 or 5x100?

At first, try 4x100, then, 4.5x100

5x100 it's kind of crazy!

 

[Crashman]

http://forumz.tomshardware.com/hardware/modules.php?name=Forums&file=viewtopic&p=628539#628539
Gives an overview of the pins for modifying voltage adjustment if there is no way to do it in BIOS.

Suicide is painless...........

 

[FUGGER]

Another option is to tape the pins on the slot 1 card.
This will give you idea on how high you can go.

http://www6.tomshardware.com/cpu/00q3/000728/celeron-05.html#what_do_i_need_to_overclock_the_celeron

Here is how you get 66Mhz CPU @ 100Mhz via taping the pins.
http://www6.tomshardware.com/cpu/98q2/980514/