Champion Pub Problems - Help :(

[dd]

Archived from groups: rec.games.pinball (More info?)

Hey guys my champion pub is really acting up. When I start a fight the
boxer is supposed to turn and fight. This is random and does not happen
every time! What would cause this? The motor works... When I start the
tests on the boxer the test sometimes works too...

 

[Guest]

Archived from groups: rec.games.pinball (More info?)

If there is a wire harness going to it that moves, suspect that, any
switches or sensors involved that let the game know what postiion the boxer
is in, check them. LTG

"dd" <armandb@sbcglobal.net> wrote in message
news:1121315012.584519.253540@g44g2000cwa.googlegroups.com...
> Hey guys my champion pub is really acting up. When I start a fight the
> boxer is supposed to turn and fight. This is random and does not happen
> every time! What would cause this? The motor works... When I start the
> tests on the boxer the test sometimes works too...
>

 

[Guest]

Archived from groups: rec.games.pinball (More info?)

If it has a motor control board, check for
cold solder joints or poor connections
at this small board.

I've never been 'under the hood' of a
CP, but it is likely to have this or similar.

Also wiring to/on the boxer as Lloyd suggests

--
Fred
TX
CARGPB#8
******************

"dd" <armandb@sbcglobal.net> wrote in message news:1121315012.584519.253540@g44g2000cwa.googlegroups.com...
> Hey guys my champion pub is really acting up. When I start a fight the
> boxer is supposed to turn and fight. This is random and does not happen
> every time! What would cause this? The motor works... When I start the
> tests on the boxer the test sometimes works too...
>

 

[dd]

Archived from groups: rec.games.pinball (More info?)

Tried most everything. I replaced the motor control board, switched out
the power driver board and still the same problem. I was told it may be
my CPU?