Component Signal from a GTX 970

[crisangelfan]

I have a 32" RCA HD TV that has two malfunctioned HDMI ports on it and no other input other than component. I know the component ports are fine because I hooked the TV up to a cable box through these ports and everything was fine. Even though the highest resolution I can get would be 1080i, its better than the small 17" 1024x768 TV I was using prior. I run two other 32" TVs both at 1080p and want to run this third, but I dont know of a way to hook it up. I tried this adapter but it did not work. Anybody have any Ideas? The other two TVs are connected through DIsplayPort and DVI, I have a free DVI-I Port and a free HDMI Port

 

[dudio]

I believe the problem you are running into is that both the HDMI and DVI-I are digital signals, and the Component is Analog.
I think you will need an 'Active' adapter to do it.

 

[crisangelfan]

I believe the problem you are running into is that both the HDMI and DVI-I are digital signals, and the Component is Analog.
I think you will need an 'Active' adapter to do it.

Could you link me a relatively cheap one. Cheap being <50$

 

[dudio]

Not sure where you are:
https://www.amazon.ca/EnjoyGadgets-Component-Converter-Adapter-Support/dp/B008MPB9YQ

 

[crisangelfan]

Not sure where you are:
https://www.amazon.ca/EnjoyGadgets-Component-Converter-Adapter-Support/dp/B008MPB9YQ

I'm in the US so that equates to just under 30USD, Thanks very much. Ill try one of these

 

[dudio]

Let us know how it goes.
Seems like a flexable, cheap solution