Question Corsair AIO showing CPU Fan Spd 0 in MSI BIOS

[toro1966]

Hey all - just built a new PC with a MEG X570 ACE and Corsair H110 240 AIO. I have the single wire 3 pin fan connection coming off the AIO connected to the CPU-Fan header as said in the directions, but in the BIOS, the Fan shows CPU fan speed 0. Two questions - should it be plugged into the Pump Header on the MB, and also, why is it reading 0. The fans are both spinning on the AIO. Also, in the iCue software from MSI, it does show both fan speeds registering. Thanks in advance for the help.

 

[Crosslhs82x2]

Sounds like the H100i is doing a pretty good job So Far.
Where did you set the pump and fan speed to?

 

[toro1966]

Thanks. Idle temps have risen to about 44-45 after the PC has been on for about hour. Not sure why, they are still fairly consistent, just higher. Will run Prime95 next!

 

[Karadjgne]

Did you try the PBO settings yet?

 

[toro1966]

What is PBO?

 

[toro1966]

Sounds like the H100i is doing a pretty good job So Far.
Where did you set the pump and fan speed to?

Balanced first, now on extreme. Temps with just browsing are about 45 deg or so.

 

[Crosslhs82x2]

This is a good start for Pbo.
https://www.tomshardware.com/reviews/ryzen-9-3900x-7-3700x-review,6214-4.html