CUBX and o/c Celeron

[Guest]

I had been overclocking a Celeron 566 to 850 in an Asus CUBX without any problems until I installed a new hard drive, a WD 205BA UDA 66. Now Windows locks up right after booting. Currently using a 250W psu, have a 300W on order in case that is the problem. I am also wondering if switching the I/O voltage setting jumper on the board to 3.6V from default 3.45V would help. Don't want to try this without advice though. Thanks for any information.

 

[Guest]

you'll find info here http://www.morningstarcomputer.com/CUBX.htm

 

[Guest]

thanks for post, but that url gets redirected to some other page saying the address is in error.

 

[Guest]

Works fine for me. Try the link:

<A HREF="http://www.morningstarcomputer.com/CUBX.htm" target="_new">http://www.morningstarcomputer.com/CUBX.htm</A>

Mike

 

[Guest]

i am not a cubx expert ... but i have a mb with hpt66 controller on it and a wd 153b hdd ... if you are using the ata66 controller make sure you are using the ata66 ide cable ... soyo recently released a new bios for the controller maybe asus has an updated bios too ... good luck

Regards,
Chas