Enthoo Pro Fan Hub

[TJReed]

So I am not sure how to use the fan hub in my enthoo pro. It says to plug the connector into the CPU_Fan Header, then plug the sata cable into the power supply to use it in the manual, but I have my cooler master hyper 212 evo fan already plugged into the cpu fan header. I would like to know how I could have them both on that header, but I have also heard that you are supposed to plug your CPU fan connector right into the fan hub, and am not sure if this is correct. I would also like to know if I can have different kinds of fans plugged into the hub if I get it to work. Thanks for any help.

 

[Sav4]

You can also plug it into a 4 pin chassis fan header instead of the CPU header, but Makesure that header is pwm .the sata goes to the power supply you may have a spare on the cable to the cd drive etc.
Which m/b do you have ?
If you look in your manual it should describe the pins for each header

 

[saxondawgs94]

The Enthoo Pro fan hub only allows you to control the speed of one fan even if you have 6 plugged into it. If you were to connect all fans into the hub you could only make them spin at the same speed. For this reason I don't suggest connecting you CPU fan into it. If I remember correctly I have my CPU fan plugged into the CPU header but where the hub is plugged in I do not know. When I get home I will check for you to let you know how I have it set up if this isnt already solved.