** key word CAN FEED ** (only if the current is asked for)
Amperage and voltage only is not a valid measurement as they are missing a key variable in Ohm's law... Resistance.
Add resistance to the equation then you'll come up with how much actual watt usage there is. This is why a 12v light bulb doesn't POP when you attach it to a car battery and still works the same when you attach to a small 12v power source. It will only draw the current it needs based on resistance.
This is also why a house with 100 amp service will run the same vacuum cleaner, toaster, microwave etc... as a house with 200 amp service. The difference is you can run MORE of them (yes I know the equations are different for AC current but same concept applies). Now... take resistance out of the equation then a 10amp 120v will cause a spark, where a 200amp 120v will cause an explosion because there's little resistance holding back the current.
If you could stack 10 130w processors together you'd end up drawing 1300w of power.
Another analogy, if I had a bucket of water and a hose the water would flow only so fast. If I had a swimming pool of water and the same hose the water would still flow exactly the same.
If you kept resistance the same, and increased voltage, you could draw more current as well (that's why processors with higher voltages draw more current). Either or you need to change something other than available current.