GPU Sag with Zotac GTX 1070 AMP! Extreme?

[pcfreaky]

Hi everyone,

I am planning on ordering a Zotac GTX 1070 AMP! Extreme.
But for some reason my GPU Support bracket does not reach for the card.....
Is it going to be a problem using the gpu without a support bracket?

Pic:
https://gyazo.com/f013857f0ec72351b459f01bea215d5b

Currently I have the Asus GTX 660. Am I doing something wrong? Because this is the only place I can screw the support bracket on.

PC Case:
AZZA GT 1

 

[abaday789]

You shouldn't have to worry about sagging very much. I have the Zotac AMP! (non-extreme). As long as it's secured properly on the rear IO with the thumb screws it should be able to support itself fine in your case without issue.

Side note: the card will require two 6+2 PCI power connectors so make sure your PSU has enough connectors as well.

 

[pcfreaky]

You shouldn't have to worry about sagging very much. I have the Zotac AMP! (non-extreme). As long as it's secured properly on the rear IO with the thumb screws it should be able to support itself fine in your case without issue.

Side note: the card will require two 6+2 PCI power connectors so make sure your PSU has enough connectors as well.

Well, I already ordered the Corsair Vengeance 650W. And from the popularity and quality of that PSU it must have all the connectors needed for modern hardware. I guess..

 

[abaday789]

Yeah that PSU should be fine for it