GVRP not working

[emirati]

i have 2 SF300 cisco switch and i want to enable the VTP but i understand the the VTP is not working on this type of the switch so i use the GVRP instead of the VTP i believe the i used the correct configuration but still not working.
if there any one who can give me an example of the GVRP configuration for the SF300 switch and tell me why its not working when i create Vlans and why the other switch is not learning the vlan from the first switch.
hope some one can help me

 

[nigelivey]

i have 2 SF300 cisco switch and i want to enable the VTP but i understand the the VTP is not working on this type of the switch so i use the GVRP instead of the VTP i believe the i used the correct configuration but still not working.
if there any one who can give me an example of the GVRP configuration for the SF300 switch and tell me why its not working when i create Vlans and why the other switch is not learning the vlan from the first switch.
hope some one can help me

For GVRP to successfully work the port must be sending the GVRP join messages, the receiving interface must be configured to receive the join messages and then the VLAN database of the advertising switch must have those VLAN manually built/defined as they are being carried in the messages... The switches must be in L3 not L2 mode.

 

[emirati]

i have 2 SF300 cisco switch and i want to enable the VTP but i understand the the VTP is not working on this type of the switch so i use the GVRP instead of the VTP i believe the i used the correct configuration but still not working.
if there any one who can give me an example of the GVRP configuration for the SF300 switch and tell me why its not working when i create Vlans and why the other switch is not learning the vlan from the first switch.
hope some one can help me

For GVRP to successfully work the port must be sending the GVRP join messages, the receiving interface must be configured to receive the join messages and then the VLAN database of the advertising switch must have those VLAN manually built/defined as they are being carried in the messages... The switches must be in L3 not L2 mode.

i tried many times but it still not working, if it's possible can you show me an example of the configuration on both switches, and what did you mean when you said the VLANS must manually build, did you mean i have to creat vlans in each switch?