Hd Tune Log, how bad is it?

[Eduardo8]

I used HDTune to see the Health of an HDD I'm formatting and I want to know how bad are the results and how much time do I have until it "dies".
Here is the log:

HD Tune Pro: SAMSUNG HD322HJ Health

ID Current Worst ThresholdData Status
(01) Raw Read Error Rate 1 1 51 35710 Failed
(03) Spin Up Time 92 92 11 3400 ok
(04) Start/Stop Count 97 97 0 2856 ok
(05) Reallocated Sector Count 100 100 10 0 ok
(07) Seek Error Rate 100 100 51 0 ok
(08) Seek Time Performance 100 100 15 0 ok
(09) Power On Hours Count 98 98 0 7818 ok
(0A) Spin Retry Count 100 100 51 0 ok
(0B) Calibration Retry Count 100 100 0 0 ok
(0C) Power Cycle Count 97 97 0 2848 ok
(0D) Soft Read Error Rate 1 1 0 35692 ok
(B7) (unknown attribute) 100 100 0 0 ok
(B8) End To End Error Detection 100 100 0 0 ok
(BB) Reported Uncorrectable Errors 100 100 0 45642 ok
(BC) Command Timeout 100 100 0 0 ok
(BE) Airflow Temperature 70 60 0 504692766 ok
(C2) Temperature 68 50 0 622133280 ok
(C3) Hardware ECC Recovered 100 100 0 959529 ok
(C4) Reallocated Event Count 100 100 0 0 ok
(C5) Current Pending Sector 94 93 0 250 warning
(C6) Offline Uncorrectable 100 100 0 0 ok
(C7) Ultra DMA CRC Error Count 100 100 0 0 ok
(C8) Write Error Rate 100 100 0 0 ok
(C9) Soft Read Error Rate 100 100 0 0 ok

Health Status : warning

Sorry for the mess, if you copy it to the notepad it should be fine and readable

 

[fzabkar]

The Raw Read Error Rate has fallen below its threshold value. This means your drive is already dead. The formatting process may reallocate the Current Pending Sectors, but I wouldn't have any confidence in it. I certainly wouldn't trust it with your data.

 

[Eduardo8]

Best answer selected by Eduardo8.